Earthing Conductivity Tester (Verifies your earthing system is conductive)
Test Your Earthing Products With The Product Conductivity Tester:
The New Earthing Conductivity Tester will confirm that your Earthing products are still conductive and working properly, we recommend testing your product regularly and after cleaning. The Product Continuity Tester will also test your Earthing cords are in good working order.
DIRECT PRODUCT TESTING:
The tester is simple to use and set up.
Make sure you have snapped on the coil cord to the tester then connect the pin end of the coil cord to your Earthing Adapter Plug that is inserted into your power outlet.
Slide the switch from the OFF to the ON position. A green LED light will quickly flash on and then off in the indicator window. This shows that your Product Tester is working.
Keep the tester ON and place it on the conductive side of your connected Earthing product.
A solid green light staying on indicates the products are working properly and are ready to use.
In the future, if you do not see the green light flash on and then off again when you turn on the Product Tester, please replace the batteries.
TESTING THROUGH A SHEET:
Add a drop of water onto your sheet or dampen your hands - this mimics the body moisture created over time when contact is made with the sheet while sleeping.
Next, firmly place the Product Tester against the wet area or place your damp hand on the sheet. A solid green light in the indicator window shows that your product is conductive and ready to ground you.
Turn off the Product Tester when not in use.
HOW TO TEST AN EARTHING CORD:
Snap one end of the cord onto the front of the Product Tester
Plug the pin end of the cord into the side of the Product Tester
Turn the Product Tester ON. A solid green light in the indicator window shows that your Cord is working properly.
Please note: This Product Tester does not test that the wall socket is Earthed - it is testing that the products and cords are all conductive and in good working order, therefore, if the socket is Earthed correctly everything should be fully functional.
This unit comes with:-
- 1 x Continuity Tester (powered by 2 x AAA batteries NOT SUPPLIED)
- 1 x 5m Cord
- Instructions
|
|
|